Changing Serial Interface Parameters - Kyocera Mita FS-8000CD Operation Manual

3.5.2

Changing Serial Interface Parameters

7
To change the communication mode, press the ENTER key. A blinking question mark
(?) appears.
>Parallel I/F
? Auto
8
Press the or
Auto
Nibble (high)
Normal
High Speed
9
When the desired communication mode is displayed, press the ENTER key.
10
Press the MENU key to exit the menu selection.
You can confirm or change the serial interface parameters including baud rate, data bits, stop
bits, parity, and protocol. These parameters must match those of the computer's serial
interface.
1
Press the MENU key.
2
Press the or
3
If the interface is other than serial, press the ENTER key. A blinking question mark (?)
appears.
Interface
? Parallel
4
Press the or
Interface
? Serial
5
Press the ENTER key again.
key to scroll through the following communication modes:
key repeatedly until Interface > appears.
key repeatedly until Serial appears.
3-39
3.5 Changing the Interface Parameters