Table of Contents
Advertisement
3.5 Changing the Interface Parameters
7
Then, press the
complete entering the subnet mask address.
8
Press the MENU key. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway address have
been properly set. To print a network status page, see
Card Status Page
Printing a Network Interface Card Status Page
You can have your printer print out a network status page when the printer prints the status
page. The network status page shows the network addresses, and other information under
various network protocols about the network interface card. The default setting is On (print).
A sample network status page is shown on
1
Press the MENU key.
2
Press the ENTER key repeatedly until Interface > appears.
Interface
Parallel
3
If the interface is other than Option, press the ENTER key. A blinking question mark
(?) appears.
Interface
? Parallel
4
Press the
or
Interface
? Option 1
5
Press the
key and then press the
>Opt. StatusPage.
>Opt. StatusPage
On
or
key to move to Gateway. Perform the same procedure to
which follows.
Figure 3-7 on page
>
key repeatedly until Option appears. Press the ENTER key.
or
3-44
Printing a Network Interface
3-46.
key repeatedly until the display shows
Advertisement
Table of Contents
