Setting The Default Font - Kyocera Mita Ecosys FS-1800+ Operation Manual

Using the Operator Panel

Setting the Default Font

Font
Internal
MENU
?
You can select the default font for the current interface. In addition to the
>
internal fonts, all fonts that are downloaded to the printer memory, or fonts
stored on a CompactFlash card, Microdrive, or option ROM, can be selected
as the default font.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
Selecting the default font
1
Press the MENU key.
2
Press the
Font
Internal
3
To select an internal font, check that Internal is displayed and
press the > key. The message display changes to that shown below. If
Internal is not displayed, press the
> I000
To select an option font, press the ENTER key while Font > is
displayed. Press
indicates Option and press the ENTER key. Pressing the > key after
that displays the font selection shown above. This operation is
possible only when option fonts are installed in the printer.
The letter before the number indicates the type of font as shown
below:
Letter
I
S
M
H
O
or key repeatedly until Font > appears.
>
or key repeatedly until the message display
Description
Internal font
Soft (down load) font
Fonts in an option CompactFlash card
Fonts in a RAM disk or option Microdrive.
Fonts in an option ROM
1-54
or key to display it.