Rear - Kyocera Mita FS-8000CD Operation Manual

1.2 Parts and Functions
1.2.3

Rear

8 Fuser Unit
The fuser unit fixes the toner permanently on the paper. The fuser becomes very hot
during printing.
9 Paper Feed Unit
The paper feed unit transports paper from the paper source for developing and fixing
images.
10 Separation Charger Cleaning Knob
This cleaning knob (green) is used to clean the separation charger. The separation
charger unit must be replaced after every 100,000 pages of printing and requires
professional servicing. Contact your Kyocera Mita dealer.
11 Primary Transfer Unit
This unit is used to create the image developed by toner and to transfer it onto the
surface of the paper.
Figure 1-4
1 Vents
Air is purged through these vents to cool down the inside.
2 Parallel Interface Connector
This connector is for a standard Centronics parallel interface cable from the computer.
Connect this connector to the computer's parallel port.
3 Paper Feeder Side Cover
This cover is opened to clear paper jams in the paper feeder section.
1-8