Chapter 7
7.12.6 Developing Cylinder
7.12.6.1
Removing
Developing Cylinder
iR2270 / iR2870 / iR3570 / iR4570
1) Remove the 6 screws [1], and detach the top cover
[2].
F-7-147
2) While freeing the claw [1], detach the sleeve front
guide [2] in the direction of the arrow.
F-7-148
3) Remove the 2 screws [1], and detach the angle
adjusting plate [2].
7-52
the
0008-0013
F-7-149
4) Remove the E-ring [1]; then, remove the washer
[2], bearing [3], gear [4], and parallel pin [5].
F-7-150
5) Remove the screw [1], and detach the gear unit [2].
F-7-151
6) Remove the sleeve bushing [1], gear [2], and
parallel pin [3].