Removing The Duplex Feed Roller 2 - Canon iR4570 Series Service Manual

1) Open the right door.
F-8-375
2) Remove the reuse band [1], and disconnect the
connector [2].
3) Remove the 2 screws (M4x8; RS tightening), and
detach the right door.
F-8-376
Attaching the Right Door
1) Match the hinge [1] found at the bottom of the right
door against the lug.
2) Engage the hinge [2] found on the top of the right
door with the hook found on the side plate.
F-8-377
When tightening the 2 screws used to fix the hinge in
place, be sure to close the right door first.
8.8.22.4 Removing the Duplex
Feed Roller 2
iR2270 / iR2870 / iR3570 / iR4570
1) Free the coil spring [1] and, at the same time,
remove the E-ring [2] to pull out the shaft [3]; then,
detach the duplex feed frame [4].
F-8-378
2) Remove the E-ring [1], and detach the one-way
Chapter 8
0007-6748
8-133