Canon iR4570 Series Service Manual page 825

Sub-item
CONFIG Selecting several types of firmware installed on the hard disk and
switching the country, language, and paper size type of this machine
<Adjustment method>
XXYYZZAAXX: Country (UP), YY: Language (ja), ZZ(00) Destination,
AA(00): Paper size type
The display contents conform to the display method of
(COPIER>DISPLAY>USER>LANGUAGE). Enclosed in the brackets
are defaults. The country and language are only displayed.
<Operating procedure>
1) Select <CONFIG>.
2) Select an item to reverse its display. Then press the + or - key to change
the contents.
3) Each time the + or - key is pressed, the contents change sequentially.
4) Display the intended contents at all items and press the OK key.
5) Turn the main power switch OFF and ON.
W/SCNR Setting whether a scanner is present (Copy model)
<Setting range>
0: Printer model [Default]
1: Model with scanner
FTPTXPN Specifying the send destination port (FTP) number
<Setting range>
0 to 65535 (Default: 21)
DFDST-L1 Adjusting the dust detection level when DF is used (Inter-paper
correction)
Setting a greater value makes it easy to detect even small particles.
<Setting range>
0 to 255
(0 to set this mode OFF) (Default: 205)
DFDST-L2 Adjusting the dust detection level when DF is used (Post-job detection)
Setting a greater value makes it easy to detect even small particles.
<Setting range>
0 to 255
(0 to set this mode OFF) (Default: 205)
CCD-LUT Setting whether or not to use LUT for gain correction
0: Do not use (Default)
1: Use (One-point correction)
2: Do not use (Three-point correction)
COPIER > OPTION > BODY
Description
Lev
el
1
1
1
1
1
1