Results Of Self-Diagnosis; Error Code (Send) - Canon iR4570 Series Service Manual

15.3 Error Code (SEND)

15.3.1 Results of Self-Diagnosis

iR2270 / iR2870 / iR3570 / iR4570
Cause
There is a shortage of TCP/IP resources. Try again later.
While continuous transmission is under way or
has ended in FTP or Windows (SMB), a
shortage of TCP/IP resources has occurred, not
permitting reference.
Set the IP address.
The IP address of the machine has yet to be set.
The server does not respond. Check the settings.
The settings of the selected server are not
correct, or the server has not been turned on.
Or, there may be a shortage of resources.
NetWare is in use. Try again later.
NetWare is printing using PSeve or
NDSPServer, not permitting browsing.
The layer in question at the target is too deep to browse.
The number of characters is in excess of the
number allowed.
There is no response.
The server is not ready for file transmission.
The network is cut for file transmission. (An
attempt to connect to the target of transmission
may have failed, or there is an open circuit in
the middle.)
The tree name is not specified for NetWare
transmission.
An error has occurred for TCP/IP in the course
of e-mail or i-fax transmission.
Check TCP/IP.
T-15-7
Remedy
Wait a while; then, try again.
In user mode, set the IP address; thereafter,
turn off and then on the machine.
Wait a while; then, try again. If browsing is still
not permitted, select a different server.
Wait until NetWare finishes printing; then, try
again.
The layer in question cannot be specified.
Specify a different address.
Check the target.
Check the network.
Type in the tree name.
Check the condition of the network cable and
the connector.
Chapter 15
0008-0278
15-33