Ethernet Network Setup - Christie RPMX-D132U User Manual

Section 2: Installation and Setup
RS-422
Communication parameters such as baud rate must be set to match the particular controlling device before
connecting as a network—refer to the documentation that came with your controlling device in order to
determine the proper baud rate. See 3.6, Adjusting System Parameters and Advanced Controls if you need help
changing the projector baud rate. Set the Network Routing to "RS-232 and RS-422 Joined" to reach all
projectors.
NOTES: 1) To avoid damage, connect only properly wired serial communication cables. See Appendix C for
details.
2) Each RS-232 communication cable must be no more than 25 feet in length. Use high quality cables.

2.4.5 Ethernet Network Setup

To add one or more projectors to an Ethernet network, use standard CAT5 cable to connect each projector's
Ethernet port to a hub belonging to the network. A controller or PC must also be connected to the hub. See
Figure 2-22 Ethernet
2-18
RS-232
1. Separate
2. RS232 and RS422 joined
3. RS232 and Ethernet joined
4. All joined
F 2-21 C
IGURE OMMUNICATING THROUGH A
Network.
To other
Ethernet
devices
F 2-22 E
IGURE
M N
IXED ETWORK
N
THERNET ETWORK
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
RS-232
020-100245-03 Rev. 1 (11-2010)