Network Routing - Christie RPMX-D132U User Manual

Section 4: Advanced Configuration and Controls
Proj key in 3.2, Using the Keypads). If you make a mistake in assigning or changing the projector number,
Exit
press to cancel.

4.7.3 Network Routing

Not applicable for stand-alone projectors or simple serial networks with only one type of controller and
NOTE:
linking.
.
SEPARATE
RS-232 AND RS-422 JOINED
RS-232 AND ETHERNET
JOINED
ALL JOINED
4-4
F 4-4 N
IGURE ETWORK
Select "Separate" (factory default) to keep RS-232, RS-422 and Ethernet messages on
their respective paths instead of being broadcast to the other types of ports. In Figure 4-
5 Using "Network Routing" Options A, RS-422 controls only the projector to which it
is connected. In Figure 4-4 Network Routing Options B, either RS-232 or RS-422 will
control the network.
Messages originating from an RS-232 or RS-422 controller will be relayed to all RS-
232 ports. Ethernet communication will not be relayed.
Messages to and from the RS-RS-232 ports will also be relayed to the Ethernet port,
and vice versa. Any RS-422 communications will be isolated.
All messages reach all ports, regardless of type
F 4-5 U "N
IGURE SING ETWORK
R O
OUTING PTIONS
R " O
OUTING PTIONS
RPMSP-D132U & RPMSP-D180U User Manual User Manual
020-100245-03 Rev. 1 (11-2010)