Connecting Sources - Christie RPMX-D132U User Manual

6. Enable Broadcast Key in the Communications menu – this enables you to switch between communicat-
ing with one or all projectors when connected serially.
7. Select Auto Setup to allow the projector to choose the best possible settings for the selected input signal.
8. Change Resize Presets if you want the image displayed at any other resolution than native.
9. Adjust Pixel Phase and Pixel Tracking from the Size and Position menu to eliminate any noise from the
displayed image.
10. Adjust H-Position and V-Position from the Size and Position menu to re-center the image on screen.
11. Adjust Size in Size and Position until the image is at the desired width then adjust Vertical Stretch.
Adjusting one option may have an affect on the other, repeat adjustment if necessary. Adjust H-Position
and V-Position again if required to center the image.
12. Adjust Color Wheel Delay if necessary. See
13. Perform Color Temperature setup.
14. Adjust Black levels and Input Levels.
15. Adjust Lamp Power to match lamp brightness of adjacent projectors, if necessary.
16. Adjust color primaries, brightness uniformity and edge blending using the detailed procedure provided in
Section Section 3
2.3

Connecting Sources

Sources connect to the Input Panel located at the back of Electronics Module.
typically accepts an RGB signal from an external analog RGB source, or it can be used for YPbPr
INPUT 1
signals or additional video sources.
analog composite video at
DVD players.
Christie offers optional input modules that can be installed into the projector at
sources. Refer to
NOTES:
1) See Section Section 7 Specifications
2) Use only high quality shielded cables for all connections.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Operation– Matching Colors in Multiple Projectors.
INPUT 2
or S-video at
INPUT 3
Appendix Section D Optional Input
for details regarding compatible inputs.
Section 4.9.6 Color Wheel Calibration —
accepts digital or analog display signals from a computer. Connect
from devices such as VCRs, laser disk players or
INPUT 4
Modules.
Section 2: Installation and Setup
Submenu.
to connect other
INPUT 5
2-11