Copying Or Deleting Channels - Christie RPMX-D132U User Manual

What Appears in Channel Setup Menu?
This menu lists all channels defined and indicates where they are connected on the input panel. The far left
column lists channel numbers currently defined. The values in the far right columns indicate horizontal and
vertical frequencies—if someone has defined a name for this channel, it appears here. Remaining columns
contain details pertaining to each channel setup, such as its switcher number (0 = projector), slot location, a
variety of icons indicating access to each channel, and an abbreviated description of each signal type. See
Editing a Channel Setup for details.
NOTE: Use
Signal Type
Both the key list and the Channel Setup menu identify signal types in a shortened form as defined in table
Channel
3.2. These descriptors indicate what signal information the projector uses to identify a match for a given
channel, and are preceded by either an "i" (interlaced signals) or "p" (progressive signal").
Table 3.3 Abbreviations for Signal Type

3.4.4 Copying or Deleting Channels

Copying channels is a quick method for creating numerous channels, each of which can then be edited and
adjusted for a variety of presentations in the future.
Copying a Channel
1. Highlight the channel in the Channel Setup menu.
2. Press to go to the Channel Copy/Delete submenu.
Func
3. Select "Copy" and press
with the next available number from 01-50.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
and to see channels not visible in the initial display of channels.
ABBREV
4WH
4WV
SG
5W
5WR
SVid
CVid
Dig
. A new channel is created (identical to original which still exists) identified
SIGNAL TYPE
Composite (4 wire) on HC input
Composite (4 wire) on V input
Sync-on-green
Separate H,V
Separate H,V swapped
S-Vid
Composite Video
Digital
Section 3: Operation
3-17