Projector Location; Lamps - Christie RPMX-D132U User Manual

Section 5: Maintenance

5.1.3 Projector Location

Operate the projector in an environment, which meets the operating range as specified in Section 6 – Specifica-
tions.
• Do not operate the projector close to water, such as near a swimming pool. Do not operate in extremely
humid environments.
• Do not place the projector on an unstable cart, stand or table. A projector and cart combination must be
used with care. Sudden stops, excessive force and uneven surfaces may cause the projector and cart com-
bination to overturn.
• Do not ceiling mount this projector.

5.1.4 Lamps

Lamps require replacement when they have reached their end of life (see Section 6 – Specifications for lamp
hours and specifications) if they have failed during operation, or have a drastic change in brightness (typical of
aging lamps). To effectively maintain operation of the projector, be aware of changes that occur in brightness
and the duration of each lamp. Refer to
Follow all safety and warning precautions regarding lamp replacement and handling.
and/or property damage. Allow a lamp to cool before handling and/or powering down and unplugging
the projector.
Use only the lamps supplied by CHRISTIE, in the Lamp Replacement Kit for these projectors.
5-2
Section 5.4.1 Replacing a lamp
Wait approximately 5 minutes to allow the lamp to cool before removing.
Do not stick hands into the lamp compartment during lamp replacement.
The lamp is under great pressure when hot and may explode causing physical injury
for more details on lamp replacement.
HOT
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)