How The Projector Works; Components; Additional Tools Required - Christie RPMX-D132U User Manual

Section 1: Introduction
• Display of RGB, NTSC, PAL, and SECAM video inputs and HDTV formats
• User adjustable lamp power
• Mechanical lamp changer for easy lamp change during operation
• Picture-in-picture display
• Edge Blending ability via software for seamless displays (only available on SXGA+ models)
• Dual frequency IR sensor for use with standard IR remote and optional long-range dual frequency remote
• 6-axis image geometry adjustment mechanism
• Memory for up to 50 custom "channels" (source setups)
• Intuitive on-screen menu system
• Built-in GPIO port to enable active control of external devices
• LED display for projector status monitoring
• Multiple control options including RS-232, RS-422 and ethernet
• On-board ChristieNET™ software
• Universal AC input 100-240 VAC, 50/60Hz
See Section 7 Specifications
1.2

How the projector works

The user selects which lamp will be in operation through the Lamp Menu; Lamp #1 or Lamp #2. After the
lamp ignites, the light generated is sequentially filtered into the RGB color primaries by the spinning color
wheel in the light engine of the projector. This filtered light is then presented to the single chip DMD, located
in the light engine. The reflected light from the DMD chip then passes through the projection lens to the screen
to display the image.
1.3

Components

Make sure you have received these components before using the projector.
• Line Cord (rated, North American)
• Configuration bracket (shipped loose, for horizontal configuration)
• 6xM6 screws (for installation of configuration bracket)
NOTE: A User's Kit is provided with each projection system. Additional User's Kits can be purchased
separately (part number 102-144100-XX).
1.4

Additional Tools Required

Keep these tools on hand during installation and setup:
#1 Phillips screw driver
1-2
for a complete list of product specifications.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)