Christie RPMX-D132U User Manual page 16

Section 2: Installation and Setup
Step 2 Modifying projector configuration (if required)
To use your projector for lens-horizontal projection then you must change its configuration. The L-shaped
bracket and M6 screws shipped with the projector are needed to complete this configuration change.
1. Unplug projector from AC.
2. Disconnect all cables between the light engine and electronics module. All disconnects must be made on
the light engine side.
3. Remove the (6) M4 screws securing the light engine module to the 6-axis adjuster, see
Light Engine.
4. Lift the light engine off the adjuster and set aside.
5. Align the shorter end of the L-shaped bracket with the mounting holes in the adjuster base, as shown in
Figure 2-4 Install configuration bracket to adjuster
6. Secure the bracket to the adjuster base with the (6) M4 screws used to secure the light engine.
2-4
F 2-3 L
IGURE
F 2-4 I
IGURE NSTALL CONFIGURATION BRACKET TO ADJUSTER BASE
L E
OOSEN IGHT NGINE
base.
6 screws
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
Figure 2-3 Loosen
020-100245-03 Rev. 1 (11-2010)