Christie RPMX-D132U User Manual page 109

6. Touch the new only lamp by its handle. Align it with the terminal plug located on the side wall of the lamp
compartment. Insert the lamp all the way in until it is fully seated – the lamp connector will plug into the
terminal plug.
7. Tighten the (3) lamp screws on the new lamp module to "lock" it in place. Lower the lamp handle until it
clips in place.
8. If the other lamp requires replacement, change the lamp position
the lamp cool and replace it using the steps described earlier in this procedure.
9. Each new lamp is supplied with a lamp card that contains lamp specific information such as the serial
number. Replace the card in the PHM when a lamp is replaced. The projector will detect the new card and
read the new lamp serial number when the projector is powered ON.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Do not stick your hands in an empty lamp compartment.
Put the lamp handle flat before requesting a lamp position change.
F 5-6 C
IGURE
F
IGURE
L P
HANGING THE AMP OSITION
5-7 L C
AMP ARD
Section 5: Maintenance
(Figure 5-6) to access the other lamp. Let
5-7