Christie RPMX-D132U User Manual page 24

Section 2: Installation and Setup
RGB signals (5 BNCs)
has 5 BNCs for connecting a variety of sources. A typical connection would be to an RGB source such
INPUT 1
as a PC, Mac, Sun, SGI and others. This projector supports multiple sync types: sync-on-green, composite
sync, and separate H & V syncs.
Connect the
SYNC
them. Then connect the red, green and blue source outputs to the
uses sync-on-green, only the red, green, and blue connections are required. If the source provides a composite
sync output, connect it to the
vertical sync outputs, connect horizontal sync to the
to input labeled
SYNC
NOTES:1)Depending on the source, you may need a custom adapter cable with BNC connectors at the
projector end and a different type of connector at the other (such as a 15-pin "D" connector for some computer
sources). Contact your dealer for details.
2) If the projector fails to recognize a signal as an RGB signal, specify the Color Space option within the Image
Settings menu. See
3) To connect YPbPr signals–such as from DVDs or analog HDTV sources–to INPUT 1, use the red, green and
blue BNCs as described in YPbPr Signals (below).
2-12
F
IGURE
BNC input(s). H & V syncs may be connected in any order, the projector will auto detect
input labeled
SYNC
See Figure 2-12.
VERT.
3.5 Adjusting the Image.
2-11 I P
NPUT ANEL
,
RED
. If the source provides separate horizontal and
HOR/COMP
input labeled
SYNC
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
, and BNCs. If the source
GREEN BLUE
and connect vertical sync
HOR/COMP
020-100245-03 Rev. 1 (11-2010)