Christie RPMX-D132U User Manual page 53

1. From the presentation level, press
3
2. Press , to display the Channel Setup menu or move the highlight to the Channel Setup option and
press . The Channel Setup menu will appear.
3. Select the relevant channel and press
The Channel Edit menu will appear similar to the sample shown in
(SAMPLE).
4. Review or edit the following channel setups in the Channel Edit menu:
•
CHANNEL NAME:
to 12 characters in length.
•
CHANNEL NUMBER:
number, a dialog message appears indicating that this number is already in use–assign a different chan-
nel number. You can define up to 50 channels.
• 1-5, corresponding to where on the projector's input panel the source is connected.
INPUT:
•
IN MENU:
this defined channel will then appear in the list available when
channel must be accessed via
NOTE: On-screen display of the channel list is an option that must be set in the Menu Preferences menu.
•
AUTO SOURCE:
ing input signal matches. If not checked, the projector can locate the selected channel only when it is
directly selected via
change.
•
LOCKED:
image settings can be adjusted. Auto Setup cannot be used with a locked channel.
•
PREVIOUS CHANNEL:
in the Channel Setup list.
•
NEXT CHANNEL:
Channel Setup list.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Menu
F 3-17 C
IGURE
An alpha-numeric label can be defined and/or changed here. Channel names can be up
A 2-digit channel number can be changed here. If you enter an existing channel
If checked (default, except for automatically defined channels with unchanged parameters),
Channel
If checked, (default), the projector can automatically locate this channel when an incom-
on the keypad—and a change in input signal will not result in a channel
Channel
If checked, all image settings for this channel are disabled. If unchecked (default), all available
Select this option to see or change Channel Edit settings for the previous channel
Select this option to see or change Channel Edit settings for the next channel in the
to display the main menu.
to edit parameters shown in the Channel Setup menu
E M (SAMPLE)
HANNEL DIT ENU
on the keypad or via the "Auto Source" function.
Section 3: Operation
Figure 3-17 Channel Edit Menu
key is pressed. If unchecked, the
Channel
3-19