NOTE: An L-shaped bracket, used to change the projector's configuration, is shipped loosely in the box with
the projector. Set this aside for future use.
Verifying all cable connections are secure. Connect any loose cables. See
Connections.
AC
AC
DVI OUT
Remove the lock screw located on the mechanical lamp changer. See
Lock
Screw. This screw is used for shipping purposes only and must be removed prior to turning the projector
on. Failure to do so can result in projector damage.
Check lamp handles. These handles must lay flat against the lamp surface otherwise they will interfere
with lamp operation.
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
IR
DVI IN
PWR
A
A
PWR
F
2-1 I
IGURE
NTERNAL
F
2-2 R
IGURE
EMOVE
Overhead View
B
B
C
C
ABLE
ONNECTIONS
L
C
L
S
AMP
HANGER
OCK
CREW
Section 2: Installation and Setup
Figure 2-1 Internal Cable
Figure 2-2 Remove Lamp Changer
2-3