System Integration Gpio Connector; Power Connection; Connecting The Projector To Ac - Christie RPMX-D132U User Manual

Section 2: Installation and Setup
1. Separate
2. RS232 and RS422 joined
3. RS232 and Ethernet joined
4. All joined
To isolate just RS-422 communications, select "RS-232 and Ethernet Joined". In
projector #3 will respond to the RS-422 controller. To isolate just Ethernet communications, select "RS-232
and RS-422 Joined"—only projector #1 will respond via Ethernet.

2.4.8 System Integration GPIO Connector

The GPIO connector on the input panel can be used to provide a method of interfacing a wide range of external
I/O devices to the projector. Refer to
to program the various pins on the connector.
2.5

Power Connection

voltage and power range.
A North American rated line cord is provided with this projector. For all other regions, make sure that
you are using a line cord, power plug and socket that meet the appropriate rating standards.

2.5.1 Connecting the projector to AC

Plug an appropriately rated line cord to the AC receptacle located on the electronics module and the 3-pronged
end into a grounded AC outlet.
NOTE: The outlet must be near the equipment and easily accessible. Use only the line cord provided with the
projector or a power cord of appropriate rating that complies with regional standards.
The input voltage to the projector must be 100-240 VAC.
2-20
RS-232
C System Integration
Do not attempt operation if the AC supply and cord are not within the specified
Do not use a line cord that is damaged.
F 2-23 A J
IGURE LL OINED
for complete details on pin configuration and how
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
RS-232
RS-422
Figure 2-23 All Joined, only
020-100245-03 Rev. 1 (11-2010)