Gui-Based Tftp Clients; Backup Via Console Port; Figure 206 System Maintenance: Backup Configuration; Table 139 General Commands For Gui-Based Tftp Clients - ZyXEL Communications P-793H User Manual

Chapter 35 Firmware and Configuration File Maintenance
tftp [-i] host get rom-0 config.rom
Where "i" specifies binary image transfer mode (use this mode when transferring
binary files), "host" is the P-793H v2 IP address, "get" transfers the file source on
the P-793H v2 (rom-0, name of the configuration file on the P-793H v2) to the file
destination on the computer and renames it config.rom.

35.3.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based
TFTP clients.

Table 139 General Commands for GUI-based TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort
Refer to
TFTP and FTP over WAN.

35.3.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure
shown next. Procedures using other serial communications programs should be
similar.
Display menu 24.5 and enter "y" at the following screen.
1

Figure 206 System Maintenance: Backup Configuration

392
DESCRIPTION
Enter the IP address of the P-793H v2. 192.168.1.1 is the P-793H v2's
default IP address when shipped.
Use "Send" to upload the file to the P-793H v2 and "Fetch" to back up the
file on your computer.
Enter the path and name of the firmware file (*.bin extension) or
configuration file (*.rom extension) on your computer.
This is the filename on the P-793H v2. The filename for the firmware is
"ras" and for the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
Section 35.3.5 on page 390
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
to read about configurations that disallow
P-793H v2 User's Guide