Printronix p300 Maintenance Manual page 215

b. Installation
PEDESTAL MODELS: (Figure 5–14)
1. Place covers (10, 13) on base (17).
2. Connect connector LBP1 (16). Verify it is fully seated.
3. Install two screws (15). Retie cable as necessary.
4. Swing card cage (14) back into place.
5. Make sure retaining clips (11) engage pegs (12).
6. Fold down rear cover (13).
7. Install nut (6) and lug (7) attached to door support cable (8) on threaded stud (9).
8. Close rear door (5) and secure fasteners (4).
9. Install six screws (3). Connect I/O cable (2) and power cord (1).
FLOOR CABINET (XQ) MODELS: (Figure 5–15)
1. Engage mounting studs (6) with keyhole slots (7). Press down on panel (3) to seat it on mounting
studs (6).
2. Tighten side panel release screw (4).
3. Connect two ground wire connectors (2) at each upper corner of right side panel (3).
4. Close cover (1).
P300/P600 Corrective Maintenance 5–33