Maca Set The Lan Ethernet Mac Address; Ifcg Print The Interface Configuration; Pppoe Enable Pppoe Mode; Masq Enable Dns Masquerade - NetComm NTC-6000 Series Command Manual

^MACA Set the LAN Ethernet MAC address
This command will set the LAN interface Ethernet MAC address.
To reset the MAC address back to the factory configured address use the command
"AT^MACA=" and then reboot the router.
Default: factory unique
Command values:
^MACA=<MAC Address> Sets the Ethernet MAC address.
^MACA?
^IFCG Print the Interface Configuration
This command will print the NTC IP interface configuration details.
Default: N/A
Command values:
^IFCG?
^PPPOE Enable PPPoE Mode
Enables or disables PPPoE mode.
Default:
Command values:
^PPPOE=0 Disable PPPoE mode.
^PPPOE=1 Enable PPPoE mode.
^MASQ Enable DNS masquerade.
Enables or disables DNS masquerading.
Default:
Command values:
^MASQ=0 Disable DNS masquerading.
^MASQ=1 Enable DNS masquerading.
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
Storage:
Queries the current Ethernet MAC address.
Storage: N/A
Prints the router‟s IP interface configuration details.
0 Storage: Automatic
0 Storage: Automatic
Page 24 of 32
7/21/2010
Automatic