Table of Contents
Advertisement
A-61139 March 2000
3. Take a sample bar code document and cut a 0.5 in. (12.5 mm)
section out of the bar code. Make sure to leave an extra inch or so
on each end of the bar code.
1 in.
25 mm
4. Position the bar code sample section on the underside of the upper
imaging guide centered on the clear surface with the start character
toward the left. Make certain the bar code can be read looking down
through the top side of the upper imaging guide.
Start character
Groove
Tape
5. Tape the bar code sample section in place.
6. Hold the upper imaging guide by the edges and carefully slide it back
into its housing. Ensure that the grooves fully engage the track.
7. Close the right-side access door.
8. Go to the section entitled, "Evaluating test results" to review the test
results.
25 mm
Right
Tape
Center line
Cutting line
0.5 in.
12.5 mm
1 in.
Upper
imaging
guide
9-13
Advertisement
Table of Contents
