Table of Contents
Advertisement
Code
Operator Message Displayed
E230
Open access door to correct error
E231
Press JOG, and try again
E232
Close all access doors and RUN
E234
Press JOG, and try again
E235
Turn main power OFF and ON
E236
E238
User function string invalid
E240
Enter correct level of IA — refeed
E241
E242
E243
E244
E245
E246
Conflicting input — what level?
E267
Clear error, re-enter IA
E280
Feeder off due to host request
A-61139 March 2000
Description/Action Required
Open the access door.
Verify all operator accessible areas are
properly closed.
Press Run to continue.
Press Jog and then press the Run key. Try
again.
Close all access doors.
Press Run to continue.
Press the Jog key and then press Run. Try
again.
Turn the side panel switch off.
Turn the main power switch off.
Wait 5 to 10 seconds.
Turn the main power switch on.
Turn the side panel switch on.
If the error repeats, call service.
The P-key, End-of-Batch, etc., definition
made during installation is invalid. Correct the
definition using the Mode Setup Software.
Set or change the document image level or
use the Next key to enter a new image
address.
Press Run to continue.
Set or change the document image level to
confirm the proper document image level.
Press Run to continue.
Press Clear. Use the Next key to enter an
image address.
Press Run to continue.
System is busy. The feeder will be
reactivated when the system is no longer
busy.
Wait until the message clears and continue.
6-5
Advertisement
Table of Contents
