Table of Contents
Advertisement
8
Using the Multi-Feed Detector
Introduction
Before you begin
A-61139 March 2000
The Kodak Digital Science Multi-Feed Detector aids in document
processing by detecting documents that may go through the feeder
one on top of the other. Multi-feeds can easily happen due to damp
documents, adhesives on documents, electrostatically charged
documents, or a maladjusted feeder gap.
NOTE: This accessory is not intended for use on machines with the
Check Feeder accessory.
For the Multi-Feed Detector to function properly be sure of the
following:
Documents must be greater than or equal to 2.5 inches (104 mm) in
length. (Length is measured parallel to the direction of feeding.)
Minimum document width is 4.5 inches.
The thickness of the documents within a batch must be the same
within ±10% from any nominal value from 2.0 to 7.0 mils.
Documents should be in good condition.
The document stack is fanned before feeding to aid in document
separation.
Labels should be placed on the documents so they do not pass
under the thickness sensor. If the labels on the document will pass
under the thickness sensor, they must be less than or equal to ½-
inch in length and spaced greater than 1-inch. They must be placed
2 inches or more from the trail and lead edges of a document.
1
8-
Advertisement
Table of Contents
