Table of Contents
Advertisement
Selecting a mode
Temporary operating
values
3-2
The scanner offers 18 modes that may be programmed for a particular
application or group of applications.
The modes are programmed at the time of installation and stored for
easy access and use.
Typically, the mode is selected via the host system, using a scanner-
unique command. However, you may manually select a mode.
To select a mode, do the following:
1. Enter function code F01 (Select Mode) by pressing the F key and
the numeric keys 0 and 1.
2. Press Enter.
3. Enter the desired mode number (modes range from 1 to 18).
4. Press Enter.
You can also check with your system administrator to see if one or
more of the P keys has been preprogrammed to perform specific
functions.
Each of the 18 modes programmed at the time of installation contain
definitions that affect the output of the scanner. Each mode is
programmed to conform to the output requirements of a particular
application or group of applications.
There may be instances, however, when a particular application
requires some variation of an existing mode. In such instances, mode
definitions may be changed using available function codes. See
Chapter 4, Function Codes, for a listing and descriptions of the
available function codes.
NOTE: Changes to mode definitions remain in effect until another mode
is selected or the side panel switch is turned off. The original
mode definition is only affected by these changes if the mode
overrides are saved (the mode override option may be selected
at installation and if selected, a plus sign (+) appears in the first
line of the status display).
Example:
If mode 15 contains definitions that allow you to use the Kodak
Imagelink Endorser, the starting print position (which defines how far
from the leading edge of the document the endorsement is printed) is
programmed to be 0.5.
If there is a special application that requires the endorsement be printed
1 inch from the leading edge of the document, you may use function
code F59 to temporarily change the starting print position.
A-61139 March 2000
Advertisement
Table of Contents
