Table of Contents
Advertisement
Feeding documents
using the semi-
automatic feeder
A-61139 March 2000
Following are document feeding instructions using the semi-automatic
feeder. After the scanner has been prepared for operation, the desired
mode and any temporary operating values have been defined, you are
ready to feed documents into the transport.
1. Verify the side panel switch is on and that any adjustments have
been made (feeder side guides, exit hopper side guides, etc.).
2. Press Run.
3. Select a stack of documents that is no more than 0.75 in. (19 mm)
thick.
4. Tap the stack of documents on a flat surface to align the edges.
5. Fan the stack of documents so the leading edge of the top
document engages the feed and separator rollers as shown:
6. Place the stack of fanned documents into the feeder so the leading
edge of the top document contacts the feed and separator rollers.
The documents are drawn into the transport, with the top document
being fed first. The documents are deposited in the exit hopper
face down, in the order in which they were fed into the transport.
7. Repeat Steps 3 through 6 until all of the application documents
have been fed into the transport.
8. Press Stop after all documents have been deposited in the exit
hopper.
Top
document
Fanned
documents
3-3
Advertisement
Table of Contents
