Kodak 9520 User Manual page 61

Code Operator Message Displayed
E281 OCR was reset — restart batch
E282 Comm buffer full — please wait
E285 Feeder off due to OCR request
E286 Feed calibration target
E291 Scanner disabled
E293 Host recovery required
E294 Front calibration warning
E295 Rear calibration warning
E296 Target not seen
E297 Document queue full
E298 Calibration required
6-6
Description/Action Required
Use the Next key to enter a starting image
address.
Rerun the batch.
System is busy. Wait until the message
clears, then continue.
System is busy. Feeder will be reactivated
when the system is no longer busy.
Wait until the message clears, then continue.
Calibration process has started.
Press Run and feed the calibration target into
the transport.
The machine has been disabled due to an
error. Determine the cause of the error via
the host system.
Enable the machine.
Press Run to continue.
Contact your system administrator to initiate
the required action on the host system.
Perform maintenance/cleaning procedures
for the Document Scanning Array, imaging
guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
Perform maintenance/cleaning procedures
for the Document Scanning Array, imaging
guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
Repeat the calibration process using a blank
target. If error repeats, call service.
The feeder and transport are stopped and
the machine is disabled.
Transfer images from the image buffer to the
host system.
Re-enable the machine.
Press Run to continue.
Enter function code F37 to initiate the
calibration sequence.
A-61139 March 2000