Kodak 9520 User Manual page 18

Adjusting the feed
shelf position
(semi-
automatic feeder only)
2-6
11. When you have adjusted the gap so the bottom document
separates consistently from the top document, rotate the gap
adjustment knob counterclockwise another 1 or 2 clicks to complete
the adjustment.
12. Feed a stack of 50 to 100 documents twice through the transport
system. Verify the final count reflects the total number of documents
fed and that the counter shows the same amount each time the
documents are counted.
If the count is not the same, the gap is not adjusted correctly.
Rotate the gap adjustment knob counterclockwise another 1 or 2
clicks and repeat Step 12. Repeat until corrected.
13. Press Stop.
14. Enter function code F04 and disable Counting Only.
15. Press Enter.
Before you begin feeding documents into the scanner, adjust the
position of the feed shelf.
To automatically feed multiple documents, the feed shelf should be in
the raised position (as shown above).
To raise the feed shelf:
1. Grasp the notch and lift the feed shelf.
2. Swing the height adjustment legs out and insert them into the
groove on the work shelf.
To hand-feed documents (one at a time), the feed shelf should be in the
down position (not shown).
To lower the feed shelf:
1. Grasp the notch and lift the feed shelf until the height adjustment
legs are no longer resting in the groove on the work shelf.
2. Tuck the height adjustment legs in and lower the feed shelf into
position.
Feed shelf
Notch
Groove
Height
adjustment
legs
Work shelf
A-61139 March 2000