Table of Contents
Advertisement
Clearing documents
The feeder/horizontal
transport area
A-61139 March 2000
Follow the steps below to clear the document path:
NOTE: Illustrations shown in this section are shown using the semi-
automatic feeder.
1. Check each transport area (Areas A through F) for documents
lodged in the document path. You only have to remove the jammed
document(s). The Jog feature places the rest of the documents in
the exit hopper. Make certain all operator-accessible areas are
firmly closed and all baffle plates are locked into place.
2. Press and hold down the Jog key to clear any remaining
documents.
3. Collect the documents located in the transport system. Put them
back into their original order, if necessary.
4. Reset the image address, level, etc., if necessary.
5. Rescan the documents. If an error code appears in the status
display, check each transport area again to make certain all
documents have been cleared.
NOTE: Green labels on handles designate operator-accessible areas.
To clear the feeder/horizontal transport area (Area A):
1. Grasp the front cover and swing it open to the right.
2. Push the roller cover release lever toward the rear of the machine.
Roller cover
3. Grasp the roller cover and rotate it up and toward the back of the
machine.
4. Remove any documents or document pieces found in the feeder.
5. Grasp and rotate the roller cover back into its original position.
6. Verify that the roller cover release lever snaps back and locks the
roller cover down into position.
7. Close the front cover.
Roller cover
release lever
Gap
release
Feed roller
lever
Separator roller
7-5
Advertisement
Table of Contents
