Table of Contents
Advertisement
Retracting the
thickness sensor
A-61139 March 2000
Under normal circumstances, you should not need to adjust the
thickness sensor manually. However, if you are feeding documents of
mixed thickness or lightweight documents, you may need to manually
retract the thickness sensor. To do this:
1. Open the front cover of the scanner.
2. Release the feeder latch and lift the top of the feeder upward.
3. Press the extended portion of the sensor in until it snaps up into the
retracted position.
NOTE: The Multi-Feed sensor is located approximately 1 inch left of
the feeder centerline as you face the scanner.
4. Place the feeder top back into its original position.
5. Close the front cover.
6. Disable the Multi-Feed Detector . See the section entitled,
"Enabling/disabling the Multi-Feed Detector " for more information.
To manually extend the thickness sensor:
1. Open the front cover of the scanner.
2. Release the feeder latch and lift the top of the feeder upward.
3. Use a pointed instrument; such as a ball-point pen, to press in on the
recessed area at the top end of the thickness sensor until it snaps
down into its operating position.
4. Place the feeder top back into its original position.
5
8-
Advertisement
Table of Contents
