Table of Contents
Advertisement
Operating the
scanner with the
Multi-Feed Detector
enabled
8-4
When the Multi-Feed Detector is enabled, the scanner is continuously
checking documents for multi-feeds when the transport is running.
When a multi-fed document is encountered, an error will be reported.
The scanner will report a document as a true multi-fed document if it
overlaps another document by ¾ of an inch or more.
When a multi-feed is detected, one of the following errors will occur
(depending upon how the scanner is configured):
If the scanner is setup to stop and display an error, an E204
message will be displayed. The transport will stop and both Multi-
Feed Detector indicators will be illuminated. To recover from an
E204 error:
- reset the image address
- reset the document stack
- start the transport again
If the scanner is setup to beep and display an error or just display
an error, an E107 message will be displayed on the status display.
The transport will continue to run, and both Multi-Feed Detector
indicators will be illuminated. To recover from an E107 error:
- reset the image address
- reset the document stack
- press either the Enable, Calibrate or Stop button in order to
reactivate the Multi-Feed Detector.
A-61139 March 2000
Advertisement
Table of Contents
