Kodak 9520 User Manual page 65

Trouble
Documents not stacking
properly.
Repeated jamming.
Clear streak on scanned
images.
Overall scanned image
density too light, too dark, or
uneven.
Calibration failure.
7-2
Probable Cause
The exit hopper side guides are
not properly adjusted.
The exit hopper end stop is not
properly adjusted.
The wrong deflector is being
used.
The transport system baffle
plates and operator-accessible
areas are not firmly closed.
There may be a foreign object
in the optical path.
Dust or dirt on the mirrors or
imaging guides.
Calibration is not performed or
is not performed correctly.
Lamps are dirty or not properly
installed.
Calibration target was skewed
when feeding.
Lamps are dirty or not properly
installed.
Document was in the transport
at the time of calibration.
Remedy
Refer to Chapter 2, "Adjusting the
exit hopper side guides and end
stop".
Refer to Chapter 2, "Adjusting the
exit hopper side guides and end
stop".
Refer to Chapter 2, "Changing the
deflector."
Repeat any recent jam clearing or
maintenance procedures, making
certain all baffle plates are firmly
in place and all operator-
accessible areas are properly
closed. Refer to "Clearing the
document path" later in this
chapter.
Check and clean imaging guides
and transport area. Refer to
Chapter 5, "Cleaning the imaging
guides".
Check and clean imaging guides
and mirrors. Refer to Chapter 5,
"Cleaning the imaging guides".
Perform calibration using
instructions provided. Refer to
Chapter 2, "Calibrating the
scanner".
Check the lamps for proper
installation. Check for dirt or
debris in the lamp housing. Refer
to Chapter 5, "Cleaning the
exposure lamp housings".
Retry. Adjust feed tray side
guides. Adjust feed and separator
roller gap.
Check the lamps for proper
installation. Check for dirt or
debris in the lamp housing. Refer
to Chapter 5, "Cleaning the
exposure lamp housings".
Remove any documents in the
transport system. Retry. Refer to
"Clearing the document path" later
in this chapter.
A-61139 March 2000