Kodak 9520 User Manual page 58

Code Operator Message Displayed
E121 Check front patch reader
E122
Check rear patch reader
E123 Command data rejected — resend
E124 Command not allowed in this model
E125
E126 Enter correct command
E127 Feeder waiting for host system
E128 Feeder adjustment warning
E130 OCR not installed
E131 Device not enabled
E132 Enable bar code first
E133 Feeder waiting for printer (Super 12
Printer only)
E140 Document Printer not installed
E141 Patch Reader not installed
E142 Detection System not installed
E143 Bar Code Reader not installed
E145 Endorser not installed
E200 Verify/enter image address
E201
A-61139 March 2000
Description/Action Required
Patch code not recognized.
Verify that the patch document was fed into
the transport in the proper orientation.
If not, refeed the path document.
If so, change to a non-patch mode to
continue; call service.
Command not recognized. Enter the
command again.
Command cannot be performed. Enter a
valid command.
Press correct key(s) for mode selected.
System is busy. No action required. Wait for
the message to clear.
Check and adjust feed and separator roller
gap.
Requested action requires installation of the
OCR accessory.
Requested action requires installation of the
Bar Code Reader.
Requested action requires that you enable
the Bar Code Reader. Enter function code
F60 to enable bar code reading.
The printer is moving into the print position;
wait until the message clears.
Requested action required installation of the
module/accessory indicated.
The required module/accessory is not
installed.
An error has occurred in the system and the
image address may no longer be correct.
Use function code F08 to determine the last
image address.
Use the Next key to correct the image
address, if necessary.
6-3