Table of Contents
Advertisement
Calibrating the
scanner
2-2
Calibration sets the intensity of the lamps, which contribute to the
overall quality of the scanned document image.
The scanner should be calibrated:
at least once a day when the scanner is turned on using the side
panel switch — prior to scanning documents
any time the scanner is turned on using the main power switch
if image quality is poor
after changing lamps
after cleaning the scanner or imaging guides
Calibrate the scanner using a calibration target (sheet of paper) that is:
Blank
Clean
Matte finish (not glossy)
White or the same color as the background color of the documents
to be scanned. If you are scanning a variety of colored documents,
use a white calibration target.
Wider than the documents you are going to scan (i.e., to scan 8.5 x
11 inch (215.9 x 279.4 mm) documents, the calibration target should
be wider than 8.5 inches (215.9 mm). The recommended width for
the calibration target is 12 inches (300 mm).
To calibrate the scanner:
1. Verify the main power and side panel switches are on. A normal
operating status display should appear.
2. Press CAL or enter function code F37 to start the calibration
sequence.
3. Insert the calibration target into the feeder.
When calibration is successful, the status display returns to a normal
operating display.
A-61139 March 2000
Advertisement
Table of Contents
