Kodak 9520 User Manual page 12

Operating keys and indicators
Key/Indicator Function
Clear/Cancel The C key allows you to:
Run Turns on the feeder and transport system.
NEXT Allows you to enter the next document image address.
Stop Allows you to stop the feeder and transport system. Documents still in the transport
system will be scanned and placed in the exit hopper before the transport system
stops.
Enter Enters data for a function code or an image address change.
Confirmation tone/alarm
1-8
Cancel a function without changing the preset values.
Clear the status display after executing specified function codes.
Clear an operator message from the status display.
The confirmation tone/alarm is located under the control panel and
sounds when one of the following conditions occur:
Run is pressed (one long tone).
Stop or End is pressed (many short tones followed by a long tone).
Feeder clutch engages/disengages (one short tone).
Incorrect key is pressed (three short tones).
When using skew detection and the document skew is greater than
what is setup in the skew parameter, or when a document is shorter
or longer than the specified length parameters (one short tone).
A bar code is detected (if the accessory is enabled and the
confirmation tone is enabled).
A patch code is detected (if the accessory is enabled and the
confirmation tone is enabled).
The Footswitch is detected (if the accessory is enabled and the
confirmation tone is enabled — one short tone).
A-61139 March 2000