Midi Device Id - Access VIRUS CLASSIC User Manual

MULTI PROGRAM CHANGE ENABLE
This function controls if the VIRUS receives program changes of multi-setups. If enabled, the VIRUS
switches an entire multi-setup by a program change. The global MIDI channel has to be used to
receive the program change. Please note that the multi program change will not work in the single-
multi mode, because, in this mode, the display is unable to show the change.

MIDI DEVICE ID

Here you can enter the identification number for system exclusive data transfer. To enable commu-
nication between two Virus units - i.e. to exchange system exclusive data - you must assign the
same MIDI DEVICE ID to both units.
MIDI CONTROL LOW PAGE
Here you can determine if you want the first 128 parameters (Page A) to be sent to MIDI-Out as sys-
tem exclusive data (SysEx) or as MIDI Controllers (Contr). When you set it to "SysEx", controller
data is disabled on the receive side; if you set it to "Contr", both controller and SysEx data are
received.
MIDI CONTROL HIGH PAGE
Here you can determine if you want the second 128 (Page B) parameters to be sent as system
exclusive data (SysEx) or as MIDI PolyPressure data (PolyPrs). When you set it to "SysEx", poly-
pressure data is disabled on the receive side; if you set it to "Contr", both polypressure and SysEx
data are received.
VIRUS CLASSIC MANUAL 129
Global And System Parameters