Knob Modes - Access VIRUS CLASSIC User Manual

Knob Modes

For all knobs with the exception of MASTER VOLUME, you can select from four operating modes in
the CONFIG menu. These are located under the menu item KNOB MODE:
Value Description
OFF
The knobs are inactive.
JUMP
In Jump Mode, the parameter jumps directly and absolutely to the
value determined by the current position of the knob.
SNAP
When you adjust a knob In Snap Mode, the original setting determines
the value until the point where the movement of the knob passes
beyond this position. In other words, the parameter does not jump to
the value as in JUMP Mode. However, keep in mind that your adjust-
ments have no effect on the parameter until the knob "snaps" on at
the position equivalent to the original value. In SNAP mode, an ®-sym-
bol appears to the right of the number. It indicates in which direction
the VALUE knob must be turned to exceed the current parameter
value.
RELATIVE
When you adjust a knob in RELATIVE Mode, the parameter is affected
immediately but not absolutely. In other words, the value change from
the original value to the value reflects precisely the amount you
adjusted via a given control. Generally this operating mode allows you
to adjust a parameter immediately, without radical jumps. However,
the down side is that in an unfavorable configuration - the worst-case
scenario being a maximum parameter value and a knob position at the
minimum value - you do not have the full control range of the knob at
your disposal. To counteract this situation, you have to turn the knob
in the opposite direction to adjust the physical knob position so that it
is equivalent to the actual parameter value. In RELATIVE Mode, the tri-
angle to the right of the number indicates if the VALUE knob coincides
with the parameter value (≤ ≤ ≤ ≤ ) or not (Ω Ω Ω Ω ).
MENU
DISPLAY
CONFIG > SYSTEM > KNOB MODE
01111111111111111112
1 SYSTEM
KnobMode
61111111111111111154
Jump≤
VIRUS CLASSIC MANUAL 47
Handling