Anycast Rp Configuration - HP 4800G Series Configuration Manual

Configured
1
Peer's Address
192.168.3.1

Anycast RP Configuration

Network requirements
The PIM-SM domain has multiple multicast sources and receivers. OSPF runs within the domain to
provide unicast routes.
It is required to configure the anycast RP application so that the receiver-side DRs and the
source-side DRs can initiate a Join message to their respective RPs that are the topologically
nearest to them.
On Switch B and Switch D, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as
a C-RP.
The router ID of Switch B is 1.1.1.1, while the router ID of Switch D is 2.2.2.2. Set up an MSDP
peering relationship between Switch B and Switch D.
Network diagram
Figure 1-7 Network diagram for anycast RP configuration
Device Interface
Source 1 —
Source 2 —
Switch A Vlan-int300
Vlan-int103
Switch B Vlan-int100
Vlan-int103
Vlan-int101
Loop0
Loop10
Loop20
Up Listen
1 0
State Up/Down time
Up 00:16:40
IP address
10.110.5.100/24
10.110.6.100/24
10.110.5.1/24
10.110.2.2/24
10.110.1.1/24
10.110.2.1/24
192.168.1.1/24
1.1.1.1/32
3.3.3.3/32
10.1.1.1/32
Connect Shutdown
0 0
AS SA Count
? 13
Device Interface
Switch C Vlan-int101
Vlan-int102
Switch D Vlan-int200
Vlan-int104
Vlan-int102
Loop0
Loop10
Loop20
Switch E Vlan-int400
Vlan-int104
1-23
Down
0
Reset Count
0
IP address
192.168.1.2/24
192.168.2.2/24
10.110.3.1/24
10.110.4.1/24
192.168.2.1/24
2.2.2.2/32
4.4.4.4/32
10.1.1.1/32
10.110.6.1/24
10.110.4.2/24