Anycast Rp Configuration - HP FlexNetwork 7500 Series Configuration Manual

[SwitchG] display msdp brief
Configured
1
Peer address
10.110.2.1
# Verify that receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data from Source 1 and
Source 2 to a multicast group. (Details not shown.)

Anycast RP configuration

Network requirements
As shown in
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can
initiate a join process to their respective RPs that are topologically closest to them.
Configure the router IDs of Switch B and Switch D as 1.1.1.1 and 2.2.2.2, respectively. Set up an
MSDP peering relationship between Switch B and Switch D.
Figure 58 Network diagram
Table 14 Interface and IP address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch B
Switch B
Established Listen
1 0
State Up/Down time
Established 00:16:40
Figure 58, OSPF runs within the domain to provide unicast routes.
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
Vlan-int300 10.110.5.1/24
Vlan-int103 10.110.2.2/24
Vlan-int100 10.110.1.1/24
Vlan-int103 10.110.2.1/24
Connect Shutdown
0 0
AS SA count
? 13
Device Interface
Switch C Vlan-int101
Switch C Vlan-int102
Switch D Vlan-int200
Switch D Vlan-int104
Switch D Vlan-int102
Switch D Loop0
171
Disabled
0
Reset count
0
IP address
192.168.1.2/24
192.168.2.2/24
10.110.3.1/24
10.110.4.1/24
192.168.2.1/24
2.2.2.2/32