Configuring Traffic Redirecting - H3C S5100-SI Operation Manual

To do...
Configure line rate
Configuration example
# Configure line rate for the incoming packets on GigabitEthernet 1/0/1, with the rate limit
being 1024 kbps.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] line-rate inbound 1024

Configuring Traffic Redirecting

Refer to Traffic Redirecting
This feature is available only on the H3C S5100-EI series switches.
Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The port that the ACL matching packets are to be redirected to has been determined.
Configuration procedures
You can configure traffic redirecting for incoming packets globally, in a VLAN, in a port
group, or on a port.
1) Configuring traffic redirecting globally
Follow these steps to configure traffic redirecting for incoming packets globally:
To do...
Enter system view
Configure traffic
redirecting
2) Configuring traffic redirecting for a VLAN
Follow these steps to configure traffic redirecting for incoming packets in a VLAN:
Use the command...
line-rate { inbound |
outbound } target-rate
for information about traffic redirecting.
Use the command...
system-view
traffic-redirect inbound acl-rule
interface interface-type
interface-number
1-32
Remarks
Required
Disabled by default.
—
Required
Remarks