Ip Performance Optimization Configuration; Ip Performance Overview; Introduction To Ip Performance Configuration; Introduction To Fib - H3C S5100-SI Operation Manual

2

IP Performance Optimization Configuration

When optimizing IP performance, go to these sections for information you are interested in:

IP Performance Overview

Configuring IP Performance Optimization

Displaying and Maintaining IP Performance Optimization Configuration
IP Performance Overview

Introduction to IP Performance Configuration

In some network environments, you can adjust the IP parameters to achieve best network performance.
The IP performance optimization configuration supported by S5100-SI/EI Series Ethernet Switches
includes:

Configuring TCP attributes

Disabling ICMP to send error packets

Introduction to FIB

Every switch stores a forwarding information base (FIB). FIB is used to store the forwarding information
of the switch and guide Layer 3 packet forwarding.
You can know the forwarding information of the switch by viewing the FIB table. Each FIB entry includes:
destination address/mask length, next hop, current flag, timestamp, and outbound interface.
When the switch runs normally, its FIB table and routing table have the same contents.

Protocols and Standards

RFC 793, Transmission Control Protocol
RFC 1323, TCP Extensions for High Performance
Configuring IP Performance Optimization

IP Performance Optimization Configuration Task List

Complete the following tasks to configure IP performance Optimization:
Configuring TCP Attributes
Disabling Sending of ICMP Error Packets
Configuring TCP Attributes
TCP optional parameters that can be configured include:
Task
Optional
Optional
2-1
Remarks