Initially Configuring A Port; Configuring Port Auto-Negotiation Speed - H3C S5100-SI Operation Manual

Initially Configuring a Port

Follow these steps to initially configure a port:
To do...
Enter system view
Enter Ethernet port view
Enable the Ethernet port
Set the description string
for the Ethernet port
Set the duplex mode of
the Ethernet port
Set the speed of the
Ethernet port
Set the medium
dependent interface
(MDI) mode of the
Ethernet port
Set the maximum frame
size allowed on the
Ethernet port to 9,216
bytes
The speed and mdi commands are not available on the combo port.
The mdi command is not available on the Ethernet ports of the expansion interface card.

Configuring Port Auto-Negotiation Speed

You can configure an auto-negotiation speed for a port by using the speed auto command.
Take a 10/100/1000 Mbps port as an example.
If you expect that 10 Mbps is the only available auto-negotiation speed of the port, you just need to
configure speed auto 10.
If you expect that 10 Mbps and 100 Mbps are the available auto-negotiation speeds of the port, you
just need to configure speed auto 10 100.
Use the command...
system-view
interface interface-type
interface-number
undo shutdown
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 | auto }
mdi { across | auto | normal }
jumboframe enable
1-2
Remarks
—
—
Optional
By default, the port is enabled.
Use the shutdown command to
disable the port.
Optional
By default, the description string of an
Ethernet port is null.
Optional
By default, the duplex mode of the
port is auto (auto-negotiation).
Optional
By default, the speed of an Ethernet
port is determined through
auto-negotiation (the auto keyword).
Optional
Be default, the MDI mode of an
Ethernet port is auto.
Optional
By default, the maximum frame size
allowed on an Ethernet is 9,216
bytes. To set the maximum frame
size allowed on an Ethernet port to
1,536 bytes, use the undo
jumboframe enable command.