H3C S5100-SI Operation Manual page 498

NDP and NTDP have been enabled on the management device and member devices, and NDP-
and NTDP-related parameters have been configured.
A cluster is established, and you can manage the member devices through the management
device.
2) Configuration procedure
Perform the following operations on the management device to synchronize SNMP configurations:
To do...
Enter system view
Enter cluster view
Create a public SNMP
community for the cluster
Create a public SNMPv3 group
for the cluster
Add a public SNMPv3 user to
the group
Create or update the public MIB
view information for the cluster
Perform the above operations on the management device of the cluster.
Configuring the public SNMP information is equal to executing these configurations on both the
management device and the member devices (refer to the SNMP-RMON Operation part in this
manual), and these configurations will be saved to the configuration files of the management
device and the member devices.
The public SNMP configurations cannot be synchronized to the devices that are on the cluster
blacklist.
If a member device leaves the cluster, the public SNMP configurations will not be removed.
3) Configuration example
# Configure the public SNMP information for the cluster on the management device, including the
following:
The read community name is read_a
The write community name is write_a
The group name is group_a
Use the command...
system-view
cluster
cluster-snmp-agent
community { read | write }
community-name [ mib-view
view-name ]
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ]
cluster-snmp-agent
usm-user v3 username
groupname
[ authentication-mode { md5 |
sha } authpassstring
[ privacy-mode { des56
privpassstring } ] ]
cluster-snmp-agent mib-view
included view-name oid-tree
2-19
Remarks
—
—
Required
Not configured by default.
Required
Not configured by default.
Required
Not configured by default.
Required
Not configured by default.