H3C S5100-SI Operation Manual page 663

Information filtering by severity works this way: information with the severity value greater than the
configured threshold is not output during the filtering.
If the threshold is set to 1, only information with the severity being emergencies will be output;
If the threshold is set to 8, information of all severities will be output.
Ten channels and six output directions of system information
The system supports six information output directions, including the Console, Monitor terminal (monitor),
logbuffer, loghost, trapbuffer and SNMP.
The system supports ten channels. The channels 0 through 5 have their default channel names and are
associated with six output directions by default. Both the channel names and the associations between
the channels and output directions can be changed through commands.
Table 1-2 Information channels and output directions
Information channel
number
0
1
2
3
4
5
6
7
8
9
Configurations for the six output directions function independently and take effect only after the
information center is enabled.
Default channel name
console
monitor
loghost
trapbuffer
logbuffer
snmpagent
channel6
channel7
channel8
channel9
1-2
Default output direction
Console (Receives log, trap and debugging
information.)
Monitor terminal (Receives log, trap and
debugging information, facilitating remote
maintenance.)
Log host (Receives log, trap and debugging
information and information will be stored in files
for future retrieval.)
Trap buffer (Receives trap information, a buffer
inside the device for recording information.)
Log buffer (Receives log information, a buffer
inside the device for recording information.)
SNMP NMS (Receives trap information.)
Not specified (Receives log, trap, and debugging
information.)
Not specified (Receives log, trap, and debugging
information.)
Not specified (Receives log, trap, and debugging
information.)
Not specified (Receives log, trap, and debugging
information.)