Configuration Task List; Saving The Current Configuration - H3C S5100-SI Operation Manual

When saving the current configuration, you can specify the file to be a main or backup or normal
configuration file.
When removing a configuration file from a switch, you can specify to remove the main or backup
configuration file. Or, if it is a file having both main and backup attribute, you can specify to erase
the main or backup attribute of the file.
When setting the configuration file for next startup, you can specify to use the main or backup
configuration file.
Startup with the configuration file
When booting, the system chooses the configuration files following the rules below:
1) If the main configuration file exists, the switch initializes with this configuration.
2) If the main configuration file does not exist but the backup configuration file exists, the switch
initializes with the backup configuration.
3) If neither the main nor the backup configuration file exists, the switch starts up without loading the
configuration file.

Configuration Task List

Complete these tasks to configure configuration file management:

Saving the Current Configuration

Erasing the Startup Configuration File
Specifying a Configuration File for Next Startup
Saving the Current Configuration
You can modify the configuration on your switch at the command line interface (CLI). To use the
modified configuration for your subsequent startups, you must save it (using the save command)
as a configuration file.
Use the following command to save current configuration:
To do...
Save current configuration
Modes in saving the configuration
Fast saving mode. This is the mode when you use the save command without the safely keyword.
The mode saves the file quicker but is likely to lose the original configuration file if the switch
reboots or the power fails during the process.
Safe mode. This is the mode when you use the save command with the safely keyword. The mode
saves the file slower but can retain the original configuration file in the switch even if the switch
reboots or the power fails during the process.
Task
Use the command...
save [ cfgfile | [ safely ]
[ backup | main ] ]
1-2
Remarks
Optional
Optional
Optional
Remarks
Required
Available in any view