Configuration Example; Enabling/Disabling The Web Server - H3C S5100-SI Operation Manual

Configuration Example

Network requirements
A user logs in to the switch through Web.
The banner page is desired when a user logs into the switch.
Network diagram
Figure 6-3 Network diagram for login banner configuration
Configuration Procedure
# Enter system view.
<Sysname> system-view
# Configure the banner Welcome to be displayed when a user logs into the switch through Web.
[Sysname] header login %Welcome%
Assume that a route is available between the user terminal (the PC) and the switch. After the
above-mentioned configuration, if you enter the IP address of the switch in the address bar of the
browser running on the user terminal and press <Enter>, the browser will display the banner page, as
shown in Figure
Figure 6-4 Banner page displayed when a user logs in to the switch through Web
Click <Continue> to enter user login authentication page. You will enter the main page of the
Web-based network management system if the authentication succeeds.

Enabling/Disabling the WEB Server

Follow these steps to enable/Disable the WEB Server:
To do...
Enter system view
6-4.
Use the command...
system-view
6-3
Remarks
—