Cluster Configuration Example; Basic Cluster Configuration Example - H3C S5100-SI Operation Manual

Cluster Configuration Example

Basic Cluster Configuration Example

Network requirements
Three switches compose a cluster, where:
An S5100 series switch serves as the management device.
The rest are member devices.
Serving as the management device, the S5100 switch manages the two member devices. The
configuration for the cluster is as follows:
The two member devices connect to the management device through GigabitEthernet 1/0/2 and
GigabitEthernet 1/0/3.
The management device connects to the Internet through GigabitEthernet 1/0/1.
GigabitEthernet 1/0/1 belongs to VLAN 2, whose interface IP address is 163.172.55.1.
All the devices in the cluster share the same FTP server and TFTP server.
The FTP server and TFTP server use the same IP address: 63.172.55.1.
The NMS and logging host use the same IP address: 69.172.55.4.
Network diagram
Figure 2-4 Network diagram for HGMP cluster configuration
Configuration procedure
1) Configure the member devices (taking one member as an example)
# Enable NDP globally and on Ethernet1/0/1.
<Sysname> system-view
[Sysname] ndp enable
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] ndp enable
[Sysname-Ethernet1/0/1] quit
# Enable NTDP globally and on Ethernet1/0/1.
[Sysname] ntdp enable
[Sysname] interface Ethernet 1/0/1
2-23