Logging In Using A Modem; Introduction; Configuration On The Switch Side; Modem Configuration - H3C S5100-SI Operation Manual

4

Logging In Using a Modem

Go to these sections for information you are interested in:

Introduction

Configuration on the Switch Side

Modem Connection Establishment
Introduction
The administrator can log in to the console port of a remote switch using a modem through public
switched telephone network (PSTN) if the remote switch is connected to the PSTN through a
modem to configure and maintain the switch remotely. When a network operates improperly or is
inaccessible, you can manage switches in the network remotely in this way.
To log in to a switch in this way, you need to configure the administrator side and the switch
properly, as listed in the following table.
Table 4-1 Requirements for logging in to a switch using a modem
Item
Administrator
side
Switch side
Configuration on the Switch Side

Modem Configuration

Perform the following configuration on the modem directly connected to the switch:
AT&F ----------------------- Restore the factory settings
ATS0=1 ----------------------- Configure to answer automatically after the first ring
AT&D ----------------------- Ignore DTR signal
AT&K0 ----------------------- Disable flow control
AT&R1 ----------------------- Ignore RTS signal
AT&S0 ----------------------- Set DSR to high level by force
ATEQ1&W ----------------------- Disable the Modem from returning command response and the
result, save the changes
The PC can communicate with the modem connected to it.
The modem is properly connected to PSTN.
The telephone number of the switch side is available.
The modem is connected to the console port of the switch properly.
The modem is properly configured.
The modem is properly connected to PSTN and a telephone set.
The authentication mode and other related settings are configured on the switch.
Refer to Table 2-3.
Requirement
4-1